Get started with Connect IT 16/48 Cellular ONLY: Insert the CORE module
Digi Connect IT® 16/48 User Guide
22
Equipment Description
Antennas (2)
Optional equipment
Equipment Description
Power cord
IEC 60320 power cord.
An additional power cord used for redundancy.
Cellular ONLY: Insert the CORE module
Note If you are connecting to a network using an Ethernet connection, you can skip this section. See
Connect hardware and connect to site network using an Ethernet LAN.
This section explains how to connect the Digi CORE®module and cellular antennas to the Connect IT
hardware.
Prerequisites
n Activated SIM card from your cellular network provider.
n CORE module. This may be included with your device. If it is not, you must purchase one
separately.
To connect the hardware and connect to the cellular network:
1. Insert your activated SIM card into the COREmodule. The notched end of SIM card should be
inserted first, with the gold metal contacts facing down. You will hear a click once the SIM is
completely inserted.
Note If one SIM card is being used, insert the SIMcard into the SIM 1 slot.
2. Insert the COREmodule into the device.
a. Orient the device so the rear of the device is facing you.
b. Remove the COREmodule slot cover from the back of the device.
c. Insert the COREmodule into the slot. Make sure the pin holes on the back of the module
match the location of the pins in the slot.
d. Push the module into the slot.
e. Push the white handle down until you hear it click.
To Next Page
Loading...
Need help?
General