Digi Connect IT 16 User Manual

Routing Virtual Router Redundancy Protocol (VRRP)
Digi Connect IT® 16/48 User Guide
220
iv. Create a SureLink test target:
(config)> add network interface eth2 ipv4 surelink target end
(config network interface eth2 ipv4 surelink target 0)>
v. Configure the type of test for the test target:
(config network interface eth2 ipv4 surelink target 0)> test value
(config network interface eth2 ipv4 surelink target 0)>
where value is one of:
n ping: Tests connectivity by sending an ICMP echo request to a specified
hostname or IP address.
l Specify the hostname or IP address:
(config network interface eth2 ipv4 surelink target 0)>
ping_host host
(config network interface eth2 ipv4 surelink target 0)>
l (Optional) Set the size, in bytes, of the ping packet:
(config network interface eth2 ipv4 surelink target 0)>
ping_size [num]
(config network interface eth2 ipv4 surelink target 0)>
n dns: Tests connectivity by sending a DNS query to the specified DNS server.
l Specify the DNS server. Allowed value is the IP address of the DNS server.
(config network interface eth2 ipv4 surelinktarget 0)> dns_
server ip_address
(config network interface eth2 ipv4 surelinktarget 0)>
n dns_configured: Tests connectivity by sending a DNS query to the DNS servers
configured for this interface.
n http: Tests connectivity by sending an HTTP or HTTPS GET request to the
specified URL.
l Specify the url:
(config network interface eth2 ipv4 surelink target 0)>
http_url value
(config network interface eth2 ipv4 surelink target 0)>
where value uses the format http[s]://hostname/[path]
n interface_up: The interface is considered to be down based on the interfaces
down time, and the amount of time an initial connection to the interface takes
before this test is considered to have failed.
l (Optional) Set the amount of time that the interface can be down before
this test is considered to have failed:

Digi Connect IT 16 Specifications

General

Brand	Digi
Model	Connect IT 16
Category	Server
Language	English