Digi Connect IT 16 User Manual

Services Enable service discovery (mDNS)
Digi Connect IT® 16/48 User Guide
430
defaultlinklocal Default Link-local IP
eth1 ETH1
eth2 ETH2
loopback Loopback
sfp1 SFP1
sfp2 SFP2
wwan WWAN
(config)>
Repeat this step to list additional interfaces.
n To limit access based on firewall zones:
(config)> add service mdns acl zone end value
Where value is a firewall zone defined on your device, or the any keyword.
Display a list of available firewall zones:
Type ... firewall zone ? at the config prompt:
(config)> ... firewall zone ?
Zones: A list of groups of network interfaces that can be
referred to by packet
filtering rules and access control lists.
Additional Configuration
---------------------------------------------------------
----------------------
any
dynamic_routes
edge
external
internal
ipsec
loopback
setup
(config)>
Repeat this step to list additional firewall zones.
5. Save the configuration and apply the change:
(config)> save
Configuration saved.
>
6. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.

Digi Connect IT 16 Specifications

General

Brand	Digi
Model	Connect IT 16
Category	Server
Language	English