Digi Connect IT 16 User Manual

Diagnostics Configure syslog servers
Digi Connect IT® 16/48 User Guide
667
d. Select the event categories that will be sent to the server. By default, all event categories
are enabled. You can disable logging for error, informational, and status event categories
by clicking to toggle off the category.
e. For Syslog egress port, type the port number to use for the syslog server. The default is
514.
f. For Protocol, select the IP protocol to use for communication with the syslog server.
Available options are TCP and UPD. The default is UPD.
5. Click Apply to save the configuration and apply the change.
Command line
1. Log into the Connect IT 16/48 command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. (Optional) To configure remote syslog servers:
a. Add a remote server:
(config)> add system log remote end
(config system log remote 0)>
b. Enable the server:
(config system log remote 0)> enable true
(config system log remote 0)>
c. Set the host name or IP address of the server:
(config system log remote 0)> server hostname
(config system log remote 0)>
d. The event categories that will be sent to the server are automatically enabled when the
server is enabled.
n To disable informational event messages:
(config system log remote 0)> info false
(config system log remote 0)>

Digi Connect IT 16 Specifications

General

Brand	Digi
Model	Connect IT 16
Category	Server
Language	English