1. SYSTEM INTRODUCTION
1-7
* When you switch the steering mode with the STBY•AUTO key, a beep sounds and
then one of the messages shown below appears. The message does not appear on
the home screen. STBY modeAUTO mode: "NAVpilot is engaged."
AUTO modeSTBY mode: "NAVpilot is disengaged."
1.3 How to Turn the Power On or Off
The Power switch ( ) on the front panel controls the power.
When you turn on the power, the equipment beeps twice and the start-up screen ap-
pears. After the startup process is completed, the [NAVIGATION WARNING] screen
appears. Read the warning, then tap [OK]. Then, the last-used display appears.
The color of the lamp in the power switch changes according to equipment state.
Green: Equipment is powered.
Orange: Equipment is not powered but power is flowing to the equipment.
To turn off the power, tap the power switch to show the [Power & Brilliance] window.
Tap [Power Off This Equipment] or [Power Off Network], then tap [OK].15 seconds af-
ter the screen goes blank, the power turns off. (The power is on for this 15 seconds.)
Note 1: If you cannot turn off the power as shown above or the display freezes, long
push the power switch until the screen goes blank.
Power
switch
Tap either of
these two.
Closes the
window.
To Next Page
Loading...
Need help?
General