Service Program Mode
M065/M066 5-2 SM
Exiting Service Mode
Select "End" from the service mode main menu, then press the "OK" key.
 To make the settings effective, turn the main switch off and on after exiting service
mode.
5.1.3 REMARKS
Display on the Control Panel Screen
Since the maximum number of characters which can be displayed on the control panel
screen is limited (12 or 17 characters), the description of SP modes displayed on the
screen needs to be abbreviated. The following are the major abbreviations used for the SP
modes for which the full description is over 12 or 17 characters.
1. Paper Type
N: Plain paper 1, N2 or Normal 2: Plain paper 2 (plain & recycled)
TC: Thick paper, Thick 1: Thick paper 1, Thick 2: Thick paper 2
TN: Thin paper
SP: Special paper
2. Color Mode [Color]
[K]: Black in B&W mode
[Y], [M], or [C]: Yellow, Magenta, or Cyan in Full Color mode
[YMC]: Only for Yellow, Magenta, and Cyan
[FC], [Cl]: Full Color mode
[FC, K], [FC, Y], [FC, M], or [FC, C]: Black, Yellow, Magenta, or Cyan in full color mode
3. Process Speed
LS: Low speed xx
RS: Regular speed xxx
HS: High speed xxx
As shown in the following table, the process speed (mm/s) depends on the print mode
(B&W or Color), resolution, and/or type of paper selected. Some SP mode settings depend
on the process speed.
To Next Page
Loading...
Need help?
General
