Service Program Mode
SM 5-5 M065/M066
System
Maintenance
Reference
5.1.4 BIT SWITCH PROGRAMMING
Do not change the bit switches unless you are told to do this by the manufacturer.
1. Start the SP mode.
2. Select the "Service" menu with "
/ " keys, and then push the "OK" key.
3. Push the "OK" key.
4. Push the "OK" key.
5. To select a bit switch, push the "
" keys.
6. Push the "OK" key.
7. Set the value with these keys:
 [Left] [Right]: Moves the cursor to one of the adjacent bits.
 [Up] [Down]: Changes a bit between "0" and "1".
 [Escape]: Goes out of the program without saving changes.
 [OK]: Goes out of the program and saves changes.
8. Push the "Escape" key one or more times until the menu "SP mode (Service) " is
shown.
9. Select "End" and push the OK key.
To Next Page
Loading...
Need help?
General
