Controller Options
M065/M066 2-42 SM
SD Card Slots
 Slot 1 [1] is used for PictBridge, Data Overwrite Security Unit, SD card for NetWare
printing.
 Slot 2 [2] is used for installing the VM card or HDD Encryption Unit or one of the
optional applications for service only (for example, updating the firmware).
2.7.2 SD CARD APPLI MOVE
Overview
The service program "SD Card Appli Move" (SP5-873) lets you copy application programs
from one SD card to another SD card.
Do not try to copy the VM card or the HDD encryption unit to another SD card.
You cannot run application programs from Slot 2. However you can move application
programs from Slot 2 to Slot 1 with the following procedure.
Consider the following limitations when you try to merge SD cards.
 The destination SD card should have the largest memory size of all the application SD
cards. Refer to the following table for the memory size of each SD card.
 Due to limitations, the VM Card (M385) can be neither merged nor moved to
another SD card. This card must be installed in Slot 2.
Outline of SD Card Appli Move
1. Choose a SD card with enough space.
 Do not use an SD card if it has been used on a computer. Normal operation is
not guaranteed when such an SD card is used.
2. Enter SP5873 "SD Card Appli Move". Then move the application from the SD card in
slot 2 to the card in slot 1.
3. Exit the SP mode
Use caution when you do the SD Card Appli Move procedure:
 The necessary data for authentication is transferred with the application
program from an SD card to another SD card. Authentication fails if you try to
use the SD card after you copy the application program from one card to
another card.
To Next Page
Loading...
Need help?
General
