Printer Installation
SM 2-5 M065/M066
Installation
2.3 PRINTER INSTALLATION
2.3.1 INSTALLATION PROCEDURE
 Keep the shipping retainers after you install the machine. You may need them in
the future if you transport the machine to another location.
Unpacking
 When lifting the machine, use the inside grips on both sides of the machine.
 If not, the machine could be dropped. This may cause an injury and may damage
the machine.
 Place no objects on the left cover or on the inner cover.
1. Remove the plastic bag.
2. Lift the machine with four people by using the inset grips on both sides of the machine.
 Do not hold the machine at the front and rear bottom corners when lifting.
 Grips must be used only for moving the machine without caster table and
paper feed unit. If these items are also installed when you move the machine,
do not use the grips.
 Do not remove the tapes before placing the machine.
 Lower the machine slowly and carefully, so as not to pinch your hands.
3. Remove the tape from the printer.
To Next Page
Loading...
Need help?
General
