Control During Operation
7-14 7SA6 Manual
C53000-G1176-C156-2
Figure 7-16 List of statistic values in DIGSI
®
4 — example
7.1.2.2 Resetting and Setting the Switching Statistics
The memories and counters for switching statistics are secured against a loss of pow-
er supply voltage. The values can, however, be set to zero, or to any desired value
within certain setting limits.
From the
DeviceFront
In the STATISTIC (see previous subsection) sub-menu (see previous subsection),
select the value to be set by using the key, and then press the key. See Figure
7-17 for an example of changing the trip counter. After a password is entered, the cur-
sor blinks and the number value is highlighted in a box. The number can be overwritten
using the number keys. If the new value is outside of the allowable range, either above
or below, then the maximum or minimum limit value appears at the bottom edge of the
screen. Confirm the change with the key.
Figure 7-17 Setting statistics values from the device front — example
From PC with
DIGSI
®
4
In the Statistic window (see previous sub-section), mark the value that is to be set.
With the
right mouse button, open a context menu and select Set. See Figure 7-18.
After the password for individual settings is entered, the previous value in the window
can be overwritten.
ENTER
ENTER
Oper. Hrs.= 3420000
Max 2147483648
ENTERENTER
Trip Count= 34
STATISTICS 08/08
---------------------
åIL3= 214.53kA
Trip Count= >34
:
To Next Page
Loading...
Need help?
General