6
6-15
4st 9.9/15/20 2008
17)
Disassembly of Clutch Cam and Cam Rod
1. Remove spring pin 2, clutch cam 3 and cam rod bushing
from cam rod 1.
·
Use spring pin tool A to remove spring pin.
· Do not reuse removed spring pin.
Spring Pin Tool A :
P/N. 345-72227-0
14) Disassembly of Pump Case (Lower)
1. Use bladed screw driver to remove oil seal 1.
13) Removing Pump Case (Lower)
1. Remove pump case (lower).
15) Assembly of Pump Case (Lower)
1. Apply engine oil to periphery of new oil seal, and install into
pump case (lower) with number side facing downward.
Oil Seal Attachment 3 1 :
P/N. 3BJ-99820-0
Driver Rod 2：
P/N. 3AC-99702-0
16) Removing Clutch Cam and Cam Rod
1. Remove cam rod bushing bolt 1, and pull cam rod 2 ass'y
upward to remove.
2. Apply OBM grease to lip of oil seal.
1 Oil seal
Do not reuse.
E_MFS20C_ch06_081216.qxd 09.1.20 5:27 PM ページ 15
To Next Page
Loading...
Need help?
General
