6-16
Lower Unit
4st 9.9/15/20 2008
18)
Inspection of Cam Rod and Clutch Cam
1. Check cam rod 1 and clutch cam 2 for crack and wear.
Replace if necessary.
19)
Assembly of Cam Rod and Clutch Cam
1. Reassemble.
Be careful of direction of cam rod.
20) Removing Drive Shaft
1. Remove pinion (B) gear nut, remove drive shaft ass'y 1 and
pinion (B) gear 2, and draw out forward (A) gear.
Bevel Gear B Nut Socket 3 :
P/N. 350-72232-0
Bevel Gear B Nut wrench 4：
P/N. 346-72231-0
· When removing drive shaft, be careful not to
give damage to shim on the bearing outer
race and not to lose the part. Shim is
reusable.
· Replace shim with new one of the same
thickness if any deformation or damage is
found on it.
21) Disassembly of Drive Shaft
1. Remove drive shaft bearing 1.
Do not reuse bearing. Be sure to replace
with new one.
Universal Puller Plate 2 :
P/N. 3AC-99750-0
Before removing, check bearing for play or
deflection. Replace if necessary.
OIL
GEARGEAR
GEAR
1
2
Forward
direction
E_MFS20C_ch06_081216.qxd 09.1.20 5:27 PM ページ 16
To Next Page
Loading...
Need help?
General
