EasyManua.ls Logo

Toro Diesel Z Master User Manual

Toro Diesel Z Master
310 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #23 background imageLoading...
Page #23 background image
SPECIFICATIONS
2-12 Z580/Z593/Z595 Diesel Service Manual
2
U.S. to Metric Conversions
To Convert Into Multiply By
Linear
Measurement
Miles
Yards
Feet
Feet
Inches
Inches
Inches
Kilometers
Meters
Meters
Centimeters
Meters
Centimeters
Millimeters
1.609
0.9144
0.3048
30.48
0.0254
2.54
25.4
Area
Square Miles
Square Feet
Square Inches
Acre
Square Kilometers
Square Meters
Square Centimeters
Hectare
2.59
0.0929
6.452
0.4047
Volume
Cubic Yards
Cubic Feet
Cubic Inches
Cubic Meters
Cubic Meters
Cubic Centimeters
0.7646
0.02832
16.39
Weight
Tons (Short)
Pounds
Ounces
Metric Tons
Kilograms
Grams
0.9078
0.4536
28.3495
Pressure
Pounds/Sq. In. Kilopascal
6.895
Work
Foot-pounds
Foot-pounds
Inch-pounds
Newton-Meters
Kilogram-Meters
Kilogram-Centimeters
1.356
0.1383
1.152144
Liquid Volume
Quarts
Gallons
Liters
Liters
0.9463
3.785
Liquid Flows
Gallons/Minute Liters/Minute
3.785
Temperature
Fahrenheit Celsius
1. Subtract 32°
2. Multiply by 5/9
U.S. to Metric Conversions

Table of Contents

Question and Answer IconNeed help?

Do you have a question about the Toro Diesel Z Master and is the answer not in the manual?

Toro Diesel Z Master Specifications

General IconGeneral
Fuel TypeDiesel
TransmissionHydrostatic
Engine TypeDiesel
Cutting Width60 inches
Fuel Tank Capacity12 gallons

Summary

SAFETY INFORMATION

Think Safety First

Essential safety practices for operation and maintenance.

SPECIFICATIONS

Z593-D & Z595-D Specifications

Technical data including configurations, power system, and mowing deck.

Z580-D Specifications

Technical data including configurations, power system, and mowing deck.

Torque Specifications

Recommended torque values for fasteners. Includes inch and metric series.

HYDRAULIC SYSTEM

Hydrostatic Tandem Pump Replacement

Procedure for replacing the hydrostatic tandem pump.

Wheel Motor Replacement

Procedure for replacing wheel motors, including removal and installation.

Purging the Hydraulic System

Procedure to remove air from the hydraulic system.

Adjusting Control Handle Neutral Position

How to adjust motion control handle neutral alignment.

Setting Hydrostatic Pump Neutral

Procedure to set the hydrostatic pump to neutral.

ENGINE

Engine Replacement

Procedures for engine removal and installation.

ELECTRICAL

Engine Starting Procedure

Steps for starting the engine, including glow plug operation.

MOWER DECKS

Mower Belt Replacement

Procedure for replacing mower deck belts.

Electric PTO Clutch Replacement

Procedure for replacing Warner and Ogura clutches.

Related product manuals