124 Program features
Contents of the assistant displays
There are two types of displays in the Start-up assistant: Main displays and
information displays. The main displays prompt the user to feed in information. The
assistant steps through the main displays. The information displays contain help texts
for the main displays. The figure below shows a typical example of both and
explanations of the contents.
Start/Stop control Selecting the source for start and stop
signals of the two external control
locations, EXT1 and EXT2
1001, 1002
Selecting between EXT1 and EXT2 1102
Defining the direction control 1003
Defining the start and stop modes 2101…2103
Selecting the use of Run enable signal 1601
Protections Setting the current and torque limits 2003, 2017
Output signals Selecting the signals indicated through
relay output RO1 and, if MREL-01 relay
output extension module is in use,
RO2…RO4.
Group 14 RELAY
OUTPUTS
Selecting the signals indicated through
analog output AO
Setting the minimum, maximum, scaling
and inversion
Group 15 ANALOG
OUTPUTS
Timed functions Setting the timed functions 36 TIMED FUNCTIONS
Selecting the timed start/stop control for
external control locations EXT1 and EXT2
1001, 1002
Selecting timed EXT1/EXT2 control 1102
Activation of timed constant speed 1 1201
Selecting timed function status indicated
through relay output RO1 or, if MREL-01
relay output extension module is in use,
RO2…RO4.
1401…1403, 1410
Selecting timed PID1 parameter set 1/2
control
4027
Name Description Set parameters
Main display Information display
1
2
1 Parameter Help text …
2 Feed-in field … help text continued
9905 MOTOR NOM VOLT
CANCEL
SAVE
00:00
PAR EDIT
220 V
REM
Set exactly as given
on the motor
nameplate
If connected to
multiple motors
EXIT
00:00
LOC
HELP
To Next Page
Loading...
Need help?
General
