To Next Page

To Previous Page

Safety 17

Safety

What this chapter contains

The chapter contains safety instructions which you must follow when installing,

operating and servicing the drive. If ignored, physical injury or death may follow, or

damage may occur to the drive, motor or driven equipment. Read the safety

instructions before you work on the drive.

Use of warnings

Warnings caution you about conditions which can result in serious injury or death

and/or damage to the equipment, and advise on how to avoid the danger. The

following warning symbols are used in this manual:

Electricity warning warns of hazards from electricity which can cause

physical injury and/or damage to the equipment.

General warning warns about conditions, other than those caused by

electricity, which can result in physical injury and/or damage to the equipment.

Other manuals for ABB ACS355

Questions and Answers:

Need help?

Do you have a question about the ABB ACS355 and is the answer not in the manual?

General

Input Voltage	200 V to 240 V AC, 380 V to 480 V AC
Frequency	47 Hz to 63 Hz
Control Method	Scalar control
Protection Features	Overcurrent, Overvoltage, Undervoltage, Overtemperature, Short circuit
Communication Interfaces	Modbus RTU, CANopen
Enclosure Rating	IP20
Operating Temperature	-10°C to +50°C (14°F to 122°F)
Storage Temperature	-40°C to +70°C (-40 to +158 °F)
Humidity	95% RH (non-condensing)
Altitude	Up to 1000 m (3280 ft) without derating