ABB ACS355 User Manual

Maintenance and hardware diagnostics 355
7. Install the new fan holder including the fan in reverse order.
8. Restore power.
Capacitors
 Reforming the capacitors
The capacitors must be reformed if the drive has been stored for a year. See section
Type designation label on page 28 for how to find out the manufacturing time from the
serial number. For information on reforming the capacitors, refer to Guide for
capacitor reforming in ACS50, ACS55, ACS150, ACS310, ACS350, ACS355,
ACS550 and ACH550 (3AFE68735190 [English]), available on the Internet (go to
http://www.abb.com
and enter the code in the Search field).
Power connections
WARNING! Read and follow the instructions in chapter Safety on page
17. Ignoring the instructions can cause physical injury or death, or
damage to the equipment.
1. Stop the drive and disconnect it from the power line. Wait for five minutes to let the
drive DC capacitors discharge. Ensure by measuring with a multimeter
(impedance at least 1 Mohm) that there is no voltage present.
2. Check the tightness of the power cable connections. Use the tightening torques
given in section Terminal and lead-through data for the power cables on page
366.
3. Restore power.
7

ABB ACS355 Specifications

General

Input Voltage	200 V to 240 V AC, 380 V to 480 V AC
Frequency	47 Hz to 63 Hz
Control Method	Scalar control
Protection Features	Overcurrent, Overvoltage, Undervoltage, Overtemperature, Short circuit
Communication Interfaces	Modbus RTU, CANopen
Enclosure Rating	IP20
Operating Temperature	-10°C to +50°C (14°F to 122°F)
Storage Temperature	-40°C to +70°C (-40 to +158 °F)
Humidity	95% RH (non-condensing)
Altitude	Up to 1000 m (3280 ft) without derating