Name: Cisco Catalyst 9400
Brand: Cisco
Rating: 4 (1 reviews)

To Next Page

To Previous Page

• If the product instance is managed by a controller, the controller will send the RUM report at the scheduled

time. If you want to trigger an ad-hoc report, you can do so in the Cisco DNA Center GUI.

----------------------------------------------------------------------------------------------------

Error Message %SMART_LIC-6-TRUST_CODE_INSTALL_SUCCESS: A new licensing trust code

was successfully installed on [chars].

Explanation:[chars] is the UDI where the trust code was successfully installed.

Recommended Action: No action is required. If you want to verify that the trust code is installed, enter the

showlicense status command in privileged EXEC mode. Look for the updated timestamp under header Trust

Code Installed: in the output.

----------------------------------------------------------------------------------------------------

Additional References for Smart Licensing Using Policy

Document TitleTopic

Command Reference (Catalyst 9400 Series

Switches)

For complete syntax and usage information for the

commands used in this chapter, see System Mangement >

System Mangement Commands in the Command Reference

of the required release.

Smart Software Manager HelpCisco Smart Software Manager Help

Cisco Smart License Utility Quick Start Setup

Guide

Cisco Smart License Utility User Guide

Cisco Smart License Utility (CSLU) installation and user

guides

Feature History for Smart Licensing Using Policy

This table provides release and related information for features explained in this module.

These features are available on all releases subsequent to the one they were introduced in, unless noted

otherwise.

System Management Configuration Guide, Cisco IOS XE Bengaluru 17.4.x (Catalyst 9400 Switches)

175

Smart Licensing Using Policy

Additional References for Smart Licensing Using Policy

Cisco Catalyst 9400 User Manual

Questions and Answers: