Cisco Catalyst 9400 User Manual

PurposeCommand or Action
]/filename ] | tftp:[[[//location ]/directory
]/filename ]}
Example:
Device(config)# boot network
ftp://user1:guessme@example.com/dir10/file1
Enables the switch to download configuration
files at system startup.
service config
Example:
Step 5
Device(config)# service config
Exits global configuration mode.end
Example:
Step 6
Device(config)# end
Saves the configuration.copy system:running-config
nvram:startup-config
Step 7
Example:
Device# copy system:running-config
nvram:startup-config
Copying Configuration Files from Flash Memory to the Startup or Running
Configuration
To copy a configuration file from flash memory directly to your startup configuration in NVRAM or your
running configuration, enter one of the commands in Step 2:
Procedure
PurposeCommand or Action
Enables privileged EXEC mode.enable
Step 1
Example:
• Enter your password if prompted.
Device> enable
Do one of the following:
Step 2
• Loads a configuration file directly into
NVRAM or
• copy filesystem:
[partition-number:][filename ]
nvram:startup-config
• Copies a configuration file to your running
configuration
• copy filesystem:
[partition-number:][filename ]
system:running-config
System Management Configuration Guide, Cisco IOS XE Bengaluru 17.4.x (Catalyst 9400 Switches)
305
Managing Configuration Files
Copying Configuration Files from Flash Memory to the Startup or Running Configuration

Cisco Catalyst 9400 Specifications

General

Brand	Cisco
Model	Catalyst 9400
Category	Switch
Language	English