Monitoring and Troubleshooting the Feature
Perform this task to monitor and troubleshoot the Configuration Replace and Configuration Rollback feature.
Procedure
Step 1 enable
Use this command to enable privileged EXEC mode. Enter your password if prompted.
Example:
Device> enable
Device#
Step 2 show archive
Use this command to display information about the files saved in the Cisco IOS configuration archive.
Example:
Device# show archive
There are currently 1 archive configurations saved.
The next archive file will be named flash:myconfiguration-2
Archive # Name
0
1 flash:myconfiguration-1 <- Most Recent
2
3
4
5
6
7
8
9
10
11
12
13
14
The following is sample output from the show archive command after several archive files of the running
configuration have been saved. In this example, the maximum number of archive files to be saved is set to
three.
Example:
Device# show archive
There are currently 3 archive configurations saved.
The next archive file will be named flash:myconfiguration-8
Archive # Name
0
1 :Deleted
2 :Deleted
3 :Deleted
4 :Deleted
5 flash:myconfiguration-5
6 flash:myconfiguration-6
7 flash:myconfiguration-7 <- Most Recent
System Management Configuration Guide, Cisco IOS XE Bengaluru 17.4.x (Catalyst 9400 Switches)
333
Configuration Replace and Configuration Rollback
Monitoring and Troubleshooting the Feature
To Next Page
Loading...
Need help?
General