Cisco Catalyst 9400 User Manual

The SDM templates contain only those commands that are defined as part of the templates. If a template
enables another related command that is not defined in the template, then this other command will be visible
when the showrunning config command is entered. For example, if the SDM template enables the switchport
voice vlan command, then the spanning-tree portfast edge command may also be enabled (although it is
not defined on the SDM template).
If the SDM template is removed, then other such related commands are also removed and have to be
reconfigured explicitly.
Note
Verifying Customizable SDM Templates
Use the following commands to verify the customizable SDM Template that will be applied.
Table 26: Commands to verify the customizable SDM template
DescriptionCommand
Displays the custom values that will be applied to the
features in the customizable SDM template.
show sdm prefer custom
Displays the values that were entered by the user in
the customizable SDM template.
show sdm prefer custom user-input
Displays the customized SDM template that is
currently active.
show sdm prefer
If any feature in the Customizable SDM template has been assigned a scale value of zero, the feature will not
be listed in the output of the show sdm prefer custom command after the device is reloaded.
Configuration Examples for SDM Templates
Examples: Displaying SDM Templates
This is an example output showing the advanced template information on Cisco Catalyst 9400 Series Supervisor
1 Module
Device#show sdm prefer
Showing SDM Template Info
This is the Access template.
Number of VLANs: 4094
Unicast MAC addresses: 65536
Overflow Unicast MAC addresses: 1024
L2 Multicast entries: 16384
Overflow L2 Multicast entries: 1024
L3 Multicast entries: 16384
Overflow L3 Multicast entries: 1024
Directly connected routes: 49152
Indirect routes: 65536
STP Instances: 1024
Security Access Control Entries: 18432
QoS Access Control Entries: 18432
System Management Configuration Guide, Cisco IOS XE Bengaluru 17.4.x (Catalyst 9400 Switches)
253
Configuring SDM Templates
Configuration Examples for SDM Templates

Cisco Catalyst 9400 Specifications

General

Brand	Cisco
Model	Catalyst 9400
Category	Switch
Language	English