Cisco Catalyst 9400 User Manual

PurposeCommand or Action
When you have finished changing the
running-configuration, save the new
configuration.
copy system:running-config
nvram:startup-config
Example:
Step 7
Device(config)# copy
system:running-config
nvram:startup-config
Examples
The following example stores the configuration file in usbflash0:
Device# copy nvram:startup-config usbflash0:switch-config
Device# configure terminal
Device(config)# boot config usbflash0:switch-config
Device(config)# end
Device# copy system:running-config nvram:startup-config
Loading the Configuration Commands from the Network
To use a network server to store large configurations, complete the tasks in this section:
Procedure
PurposeCommand or Action
Enables privileged EXEC mode.enable
Step 1
Example:
• Enter your password if prompted.
Device> enable
Saves the running configuration to an FTP,
RCP, or TFTP server.
copy system:running-config {ftp: | rcp: |
tftp:}
Example:
Step 2
Device# copy system:running-config ftp:
Enters global configuration mode.configure terminal
Example:
Step 3
Device# configure terminal
Specifies that the startup configuration file be
loaded from the network server at startup.
boot network {ftp:[[[//[username [:password
]@]location ]/directory ]/filename ] |
rcp:[[[//[username@]location ]/directory
Step 4
System Management Configuration Guide, Cisco IOS XE Bengaluru 17.4.x (Catalyst 9400 Switches)
304
Managing Configuration Files
Loading the Configuration Commands from the Network

Cisco Catalyst 9400 Specifications

General

Brand	Cisco
Model	Catalyst 9400
Category	Switch
Language	English