Cisco Catalyst 9400 User Manual

PurposeCommand or Action
• You can use this command only when the
image is in an activated state; and not when
the image is in a committed state.
Makes the changes persistent over reload.install commit
Step 5
Example:
• The install commit command completes
the new image installation. Changes are
Device# install commit
persistent across reloads until the
auto-abort timer expires.
(Optional) Rolls back the update to the last
committed version.
install rollback to committed
Example:
Step 6
Device# install rollback to committed
(Optional) Deletes all unused and inactive
software installation files.
install remove {file filesystem: filename |
inactive}
Example:
Step 7
Device# install remove inactive
Displays information about the active package.show install summary
Step 8
Example:
• The output of this command varies
according to the install commands that are
configured.
Device# show install summary
Booting a Device in Bundle Mode
There are several methods by which you can boot the device — either by copying the bin file from the TFTP
server and then boot the device, or by booting the device straight from flash or USB flash using the commands
boot flash:<image.bin> or boot usbflash0:<image.bin> .
The following procedure explains how to boot the device from the TFTP server in the bundle mode.
Procedure
PurposeCommand or Action
Sets the boot parameters.switch:BOOT=<source path of .bin file>
Example:
Step 1
switch:BOOT=tftp://10.0.0.2/cat9k_iosxe.16.06.01.SPA.bin]
switch:
switch:
switch:
Boots the device.boot
Example:
Step 2
switch:boot
System Management Configuration Guide, Cisco IOS XE Bengaluru 17.4.x (Catalyst 9400 Switches)
65
Performing Device Setup Configuration
Booting a Device in Bundle Mode

Cisco Catalyst 9400 Specifications

General

Brand	Cisco
Model	Catalyst 9400
Category	Switch
Language	English