Cisco Catalyst 9400 User Manual

PurposeCommand or Action
Enters global configuration mode.configure terminal
Example:
Step 2
Device# configure terminal
Specifies the SDM template to be used on the
switch. The keywords have these meanings:
sdm prefer { access | core | | }
Example:
Step 3
• access —Sets the switch to the Access
template.
Device(config)# sdm prefer access
• core —Sets the Core template.
The no sdm prefer command and
a default template is not supported.
Note
Returns to privileged EXEC mode.end
Example:
Step 4
Device(config)# end
Reloads the operating system.reload
Step 5
Example:
After the system reboots, you can use the show
sdm prefer privileged EXEC command to
Device# reload
verify the new template configuration. If you
enter the show sdm prefer command before
you enter the reload privileged EXEC
command, the show sdm prefer command
shows the template currently in use and the
template that will become active after a reload.
Monitoring and Maintaining SDM Templates
Verifying SDM Templates
Use the following commands to monitor and maintain SDM templates.
PurposeCommand
Displays the SDM template in use.show sdm prefer
Reloads the switch to activate the
newly configured SDM template.
reload
System Management Configuration Guide, Cisco IOS XE Bengaluru 17.4.x (Catalyst 9400 Switches)
252
Configuring SDM Templates
Monitoring and Maintaining SDM Templates

Cisco Catalyst 9400 Specifications

General

Brand	Cisco
Model	Catalyst 9400
Category	Switch
Language	English