Cisco Catalyst 9400 User Manual

Verifying Troubleshooting of the Software Configuration
Displaying OBFL Information
Table 34: Commands for Displaying OBFL Information
Command
show logging onboard RP active clilog
show logging onboard RP active environment
show logging onboard RP active message
show logging onboard RP active counter
show logging onboard RP active temperature
show logging onboard RP active uptime
show logging onboard RP active voltage
show logging onboard RP active status
Example: Verifying the Problem and Cause for High CPU Utilization
To determine if high CPU utilization is a problem, enter the show processes cpu sorted privileged EXEC
command. Note the underlined information in the first line of the output example.
Device# show processes cpu sorted
CPU utilization for five seconds: 8%/0%; one minute: 7%; five minutes: 8%
PID Runtime(ms) Invoked uSecs 5Sec 1Min 5Min TTY Process
309 42289103 752750 56180 1.75% 1.20% 1.22% 0 RIP Timers
140 8820183 4942081 1784 0.63% 0.37% 0.30% 0 HRPC qos request
100 3427318 16150534 212 0.47% 0.14% 0.11% 0 HRPC pm-counters
192 3093252 14081112 219 0.31% 0.14% 0.11% 0 Spanning Tree
143 8 37 216 0.15% 0.01% 0.00% 0 Exec
...
<output truncated>
This example shows normal CPU utilization. The output shows that utilization for the last 5 seconds is 8%/0%,
which has this meaning:
• The total CPU utilization is 8 percent, including both time running Cisco IOS processes and time spent
handling interrupts.
• The time spent handling interrupts is zero percent.
System Management Configuration Guide, Cisco IOS XE Bengaluru 17.4.x (Catalyst 9400 Switches)
412
Troubleshooting the Software Configuration
Verifying Troubleshooting of the Software Configuration

Cisco Catalyst 9400 Specifications

General

Brand	Cisco
Model	Catalyst 9400
Category	Switch
Language	English