Cisco Catalyst 9400 User Manual

Monitoring Conditional Debugging
The table shown below lists the various commands that can be used to monitor conditional debugging.
PurposeCommand
Displays the current conditions set.show platform condition
Displays the current debug conditions set.show debug
Displays logs merged from the latest tracefile.show platform software trace filter-binary
Displays historical logs of merged tracefiles on the
system.
request platform software trace filter-binary
Configuration Examples for Conditional Debugging
The following is an output example of the show platform condition command.
Device# show platform condition
Conditional Debug Global State: Stop
Conditions Direction
----------------------------------------------------------------------------------------------|---------
MAC Address 0024.D7C7.0054 N/A
Feature Condition Type Value
-----------------------|-----------------------|--------------------------------
Device#
The following is an output example of the show debug command.
Device# show debug
IOSXE Conditional Debug Configs:
Conditional Debug Global State: Start
Conditions Direction
----------------------------------------------------------------------------------------------|---------
MAC Address 0024.D7C7.0054 N/A
Feature Condition Type Value
-----------------------|-----------------------|--------------------------------
Packet Infra debugs:
Ip Address Port
------------------------------------------------------|----------
Device#
The following is a sample of the debug platform condition stop command.
Device# debug platform condition stop
Conditional Debug Global State: Stop
System Management Configuration Guide, Cisco IOS XE Bengaluru 17.4.x (Catalyst 9400 Switches)
382
Conditional Debug and Radioactive Tracing
Monitoring Conditional Debugging

Cisco Catalyst 9400 Specifications

General

Brand	Cisco
Model	Catalyst 9400
Category	Switch
Language	English