Honda Metropolitan CHF50 User Manual

FUEL SYSTEM
Remove the PAIR check valve from the valve cover.
, PAIR CHECK VALVE
Check the reed valve for damage or fatigue. Replace
if necessary.
Replace the PAIR check valve if the rubber seat is
cracked, deteriorated or damaged, or if there is
clearance between the reed and seat.
Install the PAIR check valve in the reverse order of
the removal.
Install the plug maintenance lid (page 3-6).
PAIR C H E C K V A L V E
REED V A L V E
RUBB
E R SEAT
PCV CONTROL SOLENOID VALVE/PCV
REED VALVE (After '05 model)
REMOVAL/INSTALLATION
Disconnect the air suction hoses and the PCV con-
trol solenoid valve 2P connector.
2P CONNECTOR
Remove the bolts and the PCV control solenoid
valve/stay.
PCV CONTROL SOLENOID VALVE/STAY
5-24

Honda Metropolitan CHF50 Specifications

General

Engine Type	49cc liquid-cooled single-cylinder four-stroke
Ignition	CDI
Transmission	Automatic V-Matic belt drive
Rear Suspension	Single shock
Front Brake	Drum
Rear Brake	Drum
Front Tire	80/100-10
Rear Tire	80/100-10
Seat Height	28.3 inches
Fuel Capacity	1.3 gallons
Bore x Stroke	37.8mm x 44.0mm
Compression Ratio	12.0:1
Starter	Electric
Curb Weight	179 pounds