Honda Metropolitan CHF50 User Manual

COOLING SYSTEM
Connect the water hoses and install the clamp
securely.
Install the ignition coil wire onto the wire band.
Install the following:
- Ignition coil (page 16-7)
- Lower cover (page 2-10)
- Step floor (page 2-9)
Fill the system with the recommended coolant and
bleed any air (page 6-7).
RADIATOR
REMOVAL
Drain the coolant (page 6-7).
Remove the right side cover (page 2-8).
Remove the radiator cover.
Remove the radiator joint bolt.
Disconnect the siphon hose and water hose from
the radiator.
SIPHON HOSE
Be careful not to
damage the radiator
fins while servicing
the radiator.
Remove the radiator mounting bolts.
Remove the radiator from the water pipe.
6-13

Honda Metropolitan CHF50 Specifications

General

Engine Type	49cc liquid-cooled single-cylinder four-stroke
Ignition	CDI
Transmission	Automatic V-Matic belt drive
Rear Suspension	Single shock
Front Brake	Drum
Rear Brake	Drum
Front Tire	80/100-10
Rear Tire	80/100-10
Seat Height	28.3 inches
Fuel Capacity	1.3 gallons
Bore x Stroke	37.8mm x 44.0mm
Compression Ratio	12.0:1
Starter	Electric
Curb Weight	179 pounds