Honda Metropolitan CHF50 User Manual

MAINTENANCE
ENGINE OIL
OIL LEVEL CHECK
Start the engine and let it idle for a few minutes.
Stop the engine and place the scooter on its
centerstand on a level surface.
Wait for 2 or 3 minutes after stopping the engine.
Remove the oil filler cap/dipstick and wipe the oil
from the dipstick with a clean cloth.
OIL FILLER CAP/DIPSTICK
Insert the dipstick without screwing it in, remove it
and check the oil level.
If the oil level is below or near the lower level line
on the dipstick, add the recommended oil to the
upper level.
RECOMMENDED ENGINE OIL:
Pro Honda GN4 or HP4 (without molybdenum
additives) 4-stroke oil or equivalent motor oil
API service classification: SG or Higher
Viscosity: SAE 10W-40
NOTE:
• Other viscosities shown in the chart may be used
when the average temperature in your riding
area is within the indicated range.
Reinstall the oil filler cap/dipstick.
For engine oil change, see page 3-11.
UPPER
LEVEL
LOWER
-— LEVEL
I
^•~~ SAL 20W 40, 20W 50
| SAE 15W-40, 15W-50
^ H SAE 10W 40
^•^ SAE 10W 30 ^^^M
20 40
60
80
-10 10
20 30
100°F
40'C
3-10

Honda Metropolitan CHF50 Specifications

General

Engine Type	49cc liquid-cooled single-cylinder four-stroke
Ignition	CDI
Transmission	Automatic V-Matic belt drive
Rear Suspension	Single shock
Front Brake	Drum
Rear Brake	Drum
Front Tire	80/100-10
Rear Tire	80/100-10
Seat Height	28.3 inches
Fuel Capacity	1.3 gallons
Bore x Stroke	37.8mm x 44.0mm
Compression Ratio	12.0:1
Starter	Electric
Curb Weight	179 pounds