Honda Metropolitan CHF50 User Manual

FRAME/BODY PANELS/EXHAUST SYSTEM
STEP FLOOR
REMOVAL
Remove the following:
- Body cover (page 2-7)
- Side cover (page 2-8)
Remove the screws and bolts.
Release the front end tabs of the step floor from the
leg shield.
INSTALLATION
Installation is in the reverse order of removal.
Be careful not to
damage the tabs.
At installation, be
careful not to
damage the wire
harness.
After installation, make sure the tabs on the step
floor are attached on the leg shield.
BOLT
SCREW
LEG SHIELD
REMOVAL
Remove the following:
- Front cover (page 2-4)
- Step floor (see above)
Be careful not to Release the tabs on the shield cover, then remove
damage the tabs on the shield cover.
the shield cover. Remove the screw and luggage hook.
Remove the leg shield.
INSTALLATION
At installation, be Installation is in the reverse order of removal.
careful not to
damage the wire
harness.
SHIELD COVER
LEG SHIELD
SCREW
2-9

Honda Metropolitan CHF50 Specifications

General

Engine Type	49cc liquid-cooled single-cylinder four-stroke
Ignition	CDI
Transmission	Automatic V-Matic belt drive
Rear Suspension	Single shock
Front Brake	Drum
Rear Brake	Drum
Front Tire	80/100-10
Rear Tire	80/100-10
Seat Height	28.3 inches
Fuel Capacity	1.3 gallons
Bore x Stroke	37.8mm x 44.0mm
Compression Ratio	12.0:1
Starter	Electric
Curb Weight	179 pounds