Honda Metropolitan CHF50 User Manual

ENGINE REMOVAL/INSTALLATION
ENGINE REMOVAL
Remove the step floor (page 2-9).
Drain the engine oil (page 3-11).
Drain the coolant from the system (page 6-7).
Remove the bolt and disconnect the ground cable.
Remove the rear brake arm adjusting nut, joint pin
and spring
Remove the brake cable from the belt case groove.
Disconnect the ECT sensor connector, throttle posi-
tion sensor 3P (G) connector and SE valve 2P (Bl)
connector.
Remove the wires from the clamp.
Disconnect the air supply hose from the cylinder
head cover.
Disconnect the ignition coil connectors and remove
the wire from the wire band.
ECTSENSOR
CONNECTOR
3P CONNECTOR
mmm
CONNECTORS
7-5

Honda Metropolitan CHF50 Specifications

General

Engine Type	49cc liquid-cooled single-cylinder four-stroke
Ignition	CDI
Transmission	Automatic V-Matic belt drive
Rear Suspension	Single shock
Front Brake	Drum
Rear Brake	Drum
Front Tire	80/100-10
Rear Tire	80/100-10
Seat Height	28.3 inches
Fuel Capacity	1.3 gallons
Bore x Stroke	37.8mm x 44.0mm
Compression Ratio	12.0:1
Starter	Electric
Curb Weight	179 pounds