Honda Metropolitan CHF50 User Manual

BATTERY/CHARGING SYSTEM
BATTERY
REMOVAL/INSTALLATION
Turn the ignition switch to OFF.
Open the seat and remove the maintenance cover
while releasing the two tabs.
Remove the fuse box cover by releasing the tab.
Remove the negative (-) terminal bolt and discon-
nect the negative (-) cable.
Remove the positive (+) terminal bolt and discon-
nect the fuse box/positive (+) cable.
Remove the battery band and battery.
Install the battery in the reverse order of removal.
NOTE:
• Connect the positive (+) cable first, then connect
the negative (-) cable.
• After connecting the battery cables, coat the ter-
minals with dielectric grease.
MAINTENANCE COVER
NEGATIVE (-) CABLE
FUSE BOX COVER
TERMINAL BOLT
BATTERY BAND
FUSE BOX
TERMINAL BOLT
BATTERY
15-6

Honda Metropolitan CHF50 Specifications

General

Engine Type	49cc liquid-cooled single-cylinder four-stroke
Ignition	CDI
Transmission	Automatic V-Matic belt drive
Rear Suspension	Single shock
Front Brake	Drum
Rear Brake	Drum
Front Tire	80/100-10
Rear Tire	80/100-10
Seat Height	28.3 inches
Fuel Capacity	1.3 gallons
Bore x Stroke	37.8mm x 44.0mm
Compression Ratio	12.0:1
Starter	Electric
Curb Weight	179 pounds