TROUBLESHOOTING
M-9
M-9 When starting switch is turned ON and engine started, CHECK
items flash
* Before carrying out troubleshooting, check that all the related connectors are properly inserted.
Ir Always connect any disconnected connectors before going on to the next step.
j, Check both the alternator system and the engine oil pressure system.
a) Alternator system
Cause
I
I
or above.
l 26-30V
* Start engine and
run at half throttle
NO
or above.
Iefective monitor panel
Iefective contact, or
kzonnection in wiring
iarness between alternator
:erminal R - E08 (2k- HO3 (7)
- PO2 (female) (13). or
defective alternator
Defective alternator
Remedy
Replace
Repair or
replace
20-25 1
a
To Next Page
Loading...
Need help?
General
