DISASSEMBLY AND ASSEMBLY
BUCKET CYLINDER
INSTALLATION OF BUCKET
CYLINDER ASSEMBLY
0
Carry out installation in the reverse order to
removal.
W]
* When tightening the locknut, tighten so that the
clearance between the plate and nut is 0.5 - 1.5
mm.
m1
A
*
A
*
When
aligning the position of the pin hole,
Inside surface of bushing when
assembling pin: Anti-friction compound
(LM-P)
Greasing after assembling pin: Grease
(LM-G)
never insert your fingers in the pin hole.
Adjust the shim thickness so that the clearance
between link (6) and link (7) is below 1 mm.
* Standard shim thickness: 0.8 mm, 1.5 mm
Inside surface of bushing when
A assembling
pin: Anti-friction
compound (LM-P)
Greasing after assembling pin:
a Grease (LM-G)
When aligning the position of the pin hole,
never insert your fingers in the pin hole.
Adjust the shim thickness so that the clearance
between the cylinder bottom (8) and bracket (9)
is below 1 mm.
* Standard shim thickness: 0.8 mm, 1.5 mm
Refilling with oil (hydraulic tank)
j, Add oil through the oil filler to the specified
level. Run the engine to circulate the oil through
the system. Then check the oil level again.
Bleeding air
* Bleed the air from the cylinder. For details, see
TESTING AND ADJUSTING, Bleeding air from
hydraulic cylinder.
0.5 - 1.5 mm
X10BM006
Max. 1 mm
‘7
XlOBMOl:
XlOBM014
30-140
0
To Next Page
Loading...
Need help?
General
