DISASSEMBLY AND ASSEMBLY
WORK EQUIPMENT
INSTALLATION OF WORK
EQUIPMENT ASSEMBLY
0.5-1.5mm
XlOBM006
l Carry out installation in the reverse order to
removal.
&Ilh
Fl
en tightening the locknut, tighten so that the
clearance between the plate and nut is 0.5 - 1.5
mm.
A
Inside surface of bushing when
assembling pin: Anti-friction compound
(LM-P)
Grease after assembling pin: Grease
- (LM-G)
A When aligning the position of the pin hole,
never insert your fingers in the pin hole.
* Adjust the shim thickness so that the clearance
between cylinder rod (10) and plate (11) is
below 1 mm.
j, Standard shim thickness: 0.8 mm, 1.5 mm
m
Inside surface of bushing when
- assembling
pin:
Anti-friction
compound (LM-P)
Grease after assembling pin:
a Grease (LM-G)
A When aligning the position of the pin hole,
never insert your fingers in the pin hole.
* Adjust the shim thickness so that the clearance
between boom (12) and bracket (13) is below 1
mm.
j, Standard shim thickness: 0.8 mm, 1 .O mm,
1.5 mm
Refilling with oil (hydraulic tank)
* Add oil through the oil filler to the specified
level. Run the engine to circulate the oil through
the system. Then check the oil level again.
Bleeding air
* Bleed the air from the cylinder. For details, see
TESTING AND ADJUSTING, Bleeding air from
hydraulic cylinder.
I
I
Max. 1 mm
x17FRo42
30-147
0
To Next Page
Loading...
Need help?
General
