M-II When starting switch is turned ON and engine is started,
CAUTION items flash (but when there is no abnormality
engine or CHECK items)
* Before carrying out troubleshooting, check that all the related connectors are properly inserted.
* Always connect any disconnected connectors before going on to the next step.
in
4
0
b (engine oil pressure) flashes
kl
1
harness at terminal
sensor is removed,
. Engine at low
idling.
B
B
I
i0
I
Is there continuity
between PO1
(female) (17) - (11)
(12)?
. Turn starting
switch OFF.
* Disconnect POl.
*
NO
Cause
Defective engine oil pressure
sensor
Contact of chassis ground
with wiring harness
between EO6 (male)(l) -
HO3 (13) - PO1 (female) (171
EO6(7) - HO3 (12) - FOI (16)
Defective monitor panel
M-l 1 a) Related electric circuit diagram
HO3(S16)
E08( SWP14 1
\A “A/ w\
:zor PO1 (04>20 1
/MC\ -2
Remedy
Replace
20-254
0
To Next Page
Loading...
Need help?
General
