DISASSEMBLY AND ASSEMBLY
FINAL DRIVE
DISASSEMBLY OF FINAL DRIVE
ASSEMBLY
PC25OLC-6
1. Draining oil
Remove drain plug and drain oil from final drive
case.
Final drive case: Approx. 8.0 Q
2.
Cover
Using forcing screws and eyebolts 0, remove cover
(1).
3.
Thrust washer
Remove thrust washer (2).
4.
No. 1 sun gear shaft
Remove No. 1 sun gear shaft (3).
5. No. 1 carrier assembly
1)
Remove carrier assembly (4).
2)
Disassemble carrier assembly as follows.
i) Remove mounting bolts (5), then remove
holder.
ii) Set carrier assembly (4) in press, then
using push tool Q, pull out pin (6) and
remove gear assembly (7).
iii) Remove bearing (9) and spacer (10) from
gear (8).
iv) Remove outer race (11).
I
X07HH066
30-33
0
To Next Page
Loading...
Need help?
General
