

Ol/FORK,
TRIPLE
CLAMP
200889-10
Fillint:
the
cartridt:e
with
nitrot:en
20089()'10
rSrlHint:
tha
stearint:
hlld burint:
~
~
~
....
.
~""
-'·~l:
... ···
80OQ1().10
- Close the vacuum pump.
Remove
the special tool.
•
Info
I The
filling
port must
be
positioned
at
the highest point.
Mount and tighten the
filling
screw with the a-ring.
Guideline
1 Cartridge
filling
screw
1
M4xO.5
- Clamp the cartridge in a vise using soft iaws.
•
Info
I Clamp the cartridge only lightly.
41
12
Nm
(1.5
Ibf
ft)
- Connect the connector of the special tool
to
the pressure regulator of the nitrogen
bottle.
Nitrogen charging tool
(Tl4019)
(
--
p.
238)
Filling gas - nitrogen
- Adiust the pressure regulator of the nitrogen bottle.
Guideline
1
Gas
pressure
11.2
bar (17 psi)
- Pierce the membrane with the needle of the special tool.
-
Open
valve
-
Fi
II
the cartridge for at least 15 seconds.
Guideline
1
Gas
pressure
11.2
bar (17 psi)
•
Info
I Watch the pressure regulator dial.
Ensure that the cartridge
is
filled
to
the specified pressure.
- Close the valve.
- Close the nitrogen bottle.
-
Remove
the special tool.
- Mount and tighten
filling
screw with the a-ring.
Guideline
Nitrogen
filling
screw of the fork leg
Remove
the lower triple clamp. (
--
p.
42)
- Install the lower triple clamp. (
--
p.
42)
M4xO.5
2.5
Nm
(1.84
Ibf
ft)
I
To Next Page
Loading...
Need help?
General
