EasyManuals Logo
Home>Mindray>Medical Equipment>V12

Mindray V12 User Manual

Mindray V12
587 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #19 background imageLoading...
Page #19 background image
Introduction Warnings
xvi V Series Operating Instructions
Warnings
WARNING: Only skilled/trained clinical professionals should operate this
equipment.
WARNING: It is important for the hospital or organization that uses this equipment
to perform a reasonable service/maintenance plan. Neglect of this may
result in machine breakdown or personal injury.
WARNING: Possible explosion hazard. Do not operate machine near flammable
anesthetic agents or other flammable substances. Do not use
flammable anesthetic agents (i.e., ether or cyclopropane.)
WARNING: If liquid is accidentally spilled on equipment, battery, or accessories, or
they have been immersed in liquid, contact service personnel. Do not
operate the equipment before it has been tested and approved for
further use.
WARNING: Do not disassemble, crush, heat above 100°C (212°F), or incinerate
batteries or else fire, exposion or severe burn hazard could occur.
Replace only with the Mindray P/N 0146-00-0091-01. See operator’s
manual for safety instructions. Battery is not fully charged upon
delivery. Please charge battery before initial use.
WARNING: The Lithium-ion batteries have a service life of 3 years. Please replace
your battery when it reaches the end of its service life. Failure to replace
the battery may cause serious damage to your device from battery
overheating.
WARNING: Keep batteries out of children's reach.
WARNING: Do not connect other equipment to the same MPSO (Multiple Portable
Socket Outlets i.e. Multiple outlet extension cords) with the V 12/V 21,
as it may increase system leakage current. Only use the MPSO to supply
power to the equipment.
WARNING: Devices connected to the equipment must meet the requirements of
the applicable IEC standards (e.g. IEC 60950 safety standards for
information technology equipment and IEC 60601-1 safety standards
for medical electrical equipment). The system configuration must meet
the requirements of the IEC 60601-1 medical electrical systems
standard. Any personnel who connect devices to the equipment’s
signal input/output port is responsible for providing evidence that the
safety certification of the devices has been performed in accordance to
the IEC 60601-1. If you have any questions, please contact Mindray.
WARNING: Use of the V 12/V 21 in the vicinity of explosive anesthetics and in the
presence of electromagnetic interference or power overloads caused
by electrosurgical or diathermy instruments could create a potential
hazard or could damage the monitor.
WARNING: This device is NOT suitable for use in a magnetic resonance imaging
(MRI) environment.
WARNING: Magnetic and electrical fields are capable of interfering with the proper
performance of the equipment. For this reason make sure that all
external devices operated in the vicinity of the equipment comply with
the relevant EMC requirements. Mobile phone, X-ray equipment or MRI
devices are a possible source of interference as they may emit higher
levels of electromagnetic radiation.
WARNING: This device is not intended for direct cardiac application.

Table of Contents

Other manuals for Mindray V12

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Mindray V12 and is the answer not in the manual?

Mindray V12 Specifications

General IconGeneral
BrandMindray
ModelV12
CategoryMedical Equipment
LanguageEnglish

Related product manuals