Laser Printer Reports Reports
20 - 8 V Series Operating Instructions
2. Select the Continuous button.
The strips begin to print to the thermal printer and the Continuous button changes to Abort
Continuous.
3. Select the Abort button to stop the printing.
20.5 Laser Printer Reports
20.5.1 Waveform Report
NOTE: Contact your System Administrator to find out where the laser printer is
setup on the network.
NOTE: This report contains waveforms. To configure which waveforms print in
the report, refer to "Configuring the Waveforms to Print" on page 20-4.
NOTE: This report may also be printed from the thermal printer. Refer to
"Configuring the Print Destination" on page 20-5 for additional
information.
The Waveform Report (as shown in FIGURE 20-5) prints 10 seconds of the configured waveforms plus
all the other parameters being monitored at the time the report was initiated. A marker (shown as a
triangle ) displays above the waveform grid indicating the date and time the data was recorded.
This report includes a header, waveform information, digital parameter values, and a footer.
To Next Page
Loading...
Need help?
General
