V Series Operating Instructions 10 - 5
Respiration (Resp) Resp Dialog
10.2.4 Configuring the Resp Waveform
1. Select the Resp digital or waveform tile.
2. Select the Waveform tab (as shown in FIGURE 10-3).
FIGURE 10-3 Example Resp Dialog (Waveform Tab)
3. Select the buttons described in TABLE 10-2 to configure the tab.
4. Select the Cancel or Accept button.
•The Cancel button closes the dialog without saving the settings.
•The Accept button saves the settings and closes the dialog.
10.2.5 Configuring Apnea Alarms
1. Select the Resp digital or waveform tile.
2. Select the Apnea tab (as shown in FIGURE 10-4).
NOTE: The Apnea alarm options in the Resp dialog are only enabled in the
dialog when Apnea Alarms are unlocked in the System Setup Alarms
tab. Refer to "Configuring the Alarms Tab" on page 26-5 for additional
information.
TABLE 10-2
FUNCTION DESCRIPTION SETTINGS*
Scale Configures the Resp waveform gain. 1, 2, 3, 4 and 5
Speed Configures the Resp waveform speed. 3.125 mm/sec, 6.25 mm/sec, 12.5
mm/sec, 25 mm/sec
* The factory default configuration settings are in bold.
To Next Page
Loading...
Need help?
General
