o The servo channel used by the student transmitter for transmitting
the elevator signal is displayed next to Elevator, usually Ch2.
o Check on the model if the rotation direction of the student signal is
correct. You can reverse the direction by pressing the REV/CLR
button.
Make sure that the model motor cannot start up!
o Close the menu item.
Repeat these steps to assign all control functions that the student is
allowed to control.
If the teacher switch is switched on and the connection to the student
transmitter is established, the student controls the assigned control
functions.
Important information:
If the control functions are transferred to the student, the message
STUDENT CONTROLS flashes on the status displays #2 to #8.
If the connection to the student transmitter is lost, all control functions
are returned to the teacher.
Binding can be switched off by rotating the wheel to the left while the
menu item is open.
Turn OFF the training system after completing the training. Otherwise, the student
may inadvertently re-establish the student connection by switching on the
transmitter and take control of your model.
Besides, the power consumption of the COPILOT module reduces the operating time.
To Next Page
Loading...
Need help?
General
