5.5.2.3 Ctrl.Mix
These "mixers on the control side" mix the signal of any second (Source) control
function into any (Target) control function. The mixer takes effect on all servos that
are connected to the target control function either directly or via mixer. In helicopters,
these mixers are typically used for throttle compensation. Four of these mixers are
provided in the helicopter templates.
Refer to page 128 for a detailed description of the Ctrl.Mix mixers.
5.5.2.4 Mixers on the servo side
"Mixers on the servo side" are mixers that combine up to 8 control functions in
one common output signal. Their output signals can be assigned to one or more
servos. The mixers are defined in the Setup > Define mixer menu (see section
5.3.7 "Define mixer" on page 105).
If they are assigned to a servo, these mixers can be configured in the Mixer menu
according to the requirements of the particular model.
Refer to page 130 for instructions on how to configure mixers on the servo side.
To Next Page
Loading...
Need help?
General
