2.1 Basic safety instructions
The following basic safety instructions and warnings are an essential component of
these operating instructions and are fundamentally important for device handling.
Read the instructions carefully!
Make sure that you have carefully read these operating instructions and the
following safety instructions before setting up the device for operation.
Radio-controlled models are not toys in the usual sense. Assembly, installation, and
operation of the RC system require technical knowledge, care, safety-awareness
and responsibility. Errors or negligence can lead to considerable damage. Since the
manufacturer or the seller does not have any influence and control over the proper
setting up and operation of a model, such risks are expressly pointed out here and
any liability whatsoever is excluded.
A model that goes out of control for whatever reasons can cause significant damage
to property or personal injury. Be aware of safety at all times. Make sure to take out
general liability insurance.
Do not modify the radio control system. Use only original accessories and spare parts.
If the device is operated in combination with third-party products, ascertain their
quality and functional reliability. Each new or changed combination must undergo
careful functional testing, including a range check. Do not operate the device or
model if there appear to be any problems. First identify the error and troubleshoot it.
In particular, have the radio control transmitter and the receiver inspected at an
authorised MULTIPLEX Service Centre (see section 10.1 "Specifications" on
page 212) at regular intervals (every 2 to 3 years).
Operate the transmitter only in the permissible temperature range (see section 10.1
"Specifications" on page 212). Bear in mind that condensation may form in the
transmitter due to sudden temperature changes (e.g. warm car, cold environment).
Moisture may impair the function of the transmitter and other components of the
radio control system.