3.7 Trainer mode
The trainer mode (teacher / student) is the safest method for beginners to get
started in model sport.
An experienced model pilot has control over the model as the teacher. The trainer
can transfer control functions to the student by operating a button. Initially these will
be individual control functions, and later all the main control functions.
The PROFI TX can be configured either as a teacher transmitter or as a student
transmitter. The teacher and student transmitters are inter-connected using a
second M-LINK radio link.
If the radio link between the student and the teacher is interrupted, all the control
functions are returned to the teacher.
Student mode
In Student mode, the control signals of the sticks and sliders are transferred via
M-LINK to the teacher transmitter (without trim and travel settings).
A second PROFI TX with COPILOT module or another MULTIPLEX transmitter
with trainer stick can be used as the teacher transmitter.
Refer to "Training" on page 96 for details.
Teacher mode
A free switch on the teacher transmitter and the COPILOT module are required for
the Teacher mode (see section 10.2 "Accessories" on page 213):
Refer to section 3.3.4 "Installing additional controls" on page 37 for
installation instructions.
The assignment of the switch to the trainer function is described in section
6.4.2 "Assigning switches" on page 171.
Refer to section 3.3.5 "Installing additional modules" on page 40 for
information on how to install the COPILOT module.
In Teacher mode, the selected control functions can be controlled by the student
transmitter. These control functions are selected in the Setup > Training menu.
The selection list is only available in Teacher mode.
To Next Page
Loading...
Need help?
General
