Governor ON for electric helicopters with brushles s motors in Governor mode
In Governor mode, the speed controller (governor) provides for a constant system
speed. It merely requires a fixed value for the required system speed in the
respective flight phase. The throttle curve can be switched off in the
ControlFunctions > Throttle menu by choosing the setting Governor = ON.
5.4.4 Spoiler, Flap, Retract.Gear, Speed, Aux-1 to Aux-4
The following control functions operate identically:
Spoiler, Flap, Retract.Gear, and Aux-1 to Aux-4 for fixed-wing models
Spoiler, Speed, Retract.Gear, and Aux-1 to Aux-4 for helicopter models
Slow
Slow function: 0.0s to 6.0s
You can use this parameter to reduce the actuation time for the control function;
i.e. the connected servos travel from one end to the other during this time.
Fixed value
Flight phase specific: -100%.. 0, OFF, 0.. +100%
Allows setting a control function to fixed positions that are dependent on the
flight phase. If OFF is selected the function is controlled by the assigned control,
provided an assignment exists. If this is not the case, refer to page 101.
Example of the Flap control function
Objective: Fixed, optimised flap position (camber) in specific flight phases.
You use 3 flight phases: SPEED1, NORMAL, THERMAL1.
Preparation: Use the GLIDER+ model template. A 3-position switch must
be assigned to the phases 1-3 for switching between the flight phases
(see page 104).
To Next Page
Loading...
Need help?
General
