5.3.3 Training (principle)
In trainer mode (teacher / student), a wireless connection is established between
two Multiplex transmitters via M-LINK.
The teacher transmitter controls the model and must be bound to the model
(Binding). The student transmitter transfers the stick signal to the teacher
transmitter via M-LINK. The teacher can transfer a freely definable group of control
signals to the student.
The teacher transmitter requires a receiving device for the student signal. On older
transmitters with DIN socket, the trainer stick is the receiving device; the PROFI TX
uses the COPILOT module.
The trainer stick or the COPILOT module are bound in the same way to the student
transmitter (Binding) as receivers.
5.3.3.1 Student mode
Set Training to ON. This activates the training system.
Set "Format" to MPX if the teacher uses an older Multiplex transmitter that
does not support the UNI format.
Set Mode to Student.
Now, the student transmitter must be bound to the receiving device of the
teacher transmitter. For this, "Binding" must be activated on both sides.
o Activate "Binding": The display changes to seeking...
o Now, activate "Binding" on the receiving device of the teacher
transmitter. Place the front of the PROFI TX close to the receiving
device of the teacher transmitter.
o After a few moments, the "Binding" display changes from
seeking.. to Teacher.
This indicates that the radio link to the receiving device of the teacher transmitter
has been established.
To Next Page
Loading...
Need help?
General
