4 Model templates
PROFI TX provides the following model templates:
Templates for fixed-wing models
BASIC, see page 57
ACRO, see page 59
GLIDER+, see page 59
DELTA WING, see page 64
FLYING WING, see page 66
BIG SCALE, see page 68
Templates for helicopter models:
FUNCOPTER, see page 73
eHeli FBL, see page 74
HELImech., see page 75
HELIccpm, see page 75
Templates for land- or water-based models and tracked vehicles
CAR / TRUCK, see page 78
SHIP / BOAT, see page 80
TRACKED V., see page 83
Switch assignment
In the PROFI TX, all the switches can be installed and connected as needed. For
this reason, switched functions that are usually assigned to dip-switches or buttons
cannot be pre-set in the model templates. You have to configure these
assignments yourself according to the existing switches.
Using timers
The Frame, Sum, and Interval timers are only functional if a switch has been
assigned to them. The same control used for the Throttle control function is
assigned to the sum timer in all model templates. For this reason, this timer is
immediately functional. You activate the other timers by assigning a switch to them.
Control mixers (Ctrl.Mix)
The control mixers Ctrl.Mix are not initialised in the templates.
To Next Page
Loading...
Need help?
General
