lnstallation
A
3-25
Closing
the Electrical
Enclosure
After
you
have completed electrical installation,
follow this
procedure
to
close
the electrical enclosure.
1. Reconnect
any
ground
wires
that may have
become disconnected
during electrical
installation.
2.
Raise the control-end frame into
place
and tighten the captive screws
on each side of the frame. You may
need to
pull
the front and rear
panels
apart to
position
the frame.
3. Position the electrical enclosure
lid on top of the unit and secure it
with the
captive screws.
4.
Remove the lock-out and turn on
the
power
at the branch circuit
disconnect switch.
@000 Nordson
Corporation
All rights reserued
41-3000v
lssued
5/00
A3EN-04-[3V-X-4XXVI-1
3
To Next Page
Loading...
Need help?
General
