Nordson 3100V Series Customer Product Manual

A 3-46
lnstallation
To Delete a
Standby or Heater
Time
Follow
this
procedure
to delete a
Standby or Heater
set time.
1.
From the
System Setup
area,
press
the Move
Up
and Move Down
keys
until the light
next to the feature
you
wish
to change turns on.
NOTE: lf
you
have
enabled
the
password
feature,
you
must change
the number
in the Multipurpose
display
(500)
to
the
password (321)
and
press
the Enter
key before
the system will
allow
you
to change
the clock settings.
2.
Check the
Selector display. The
display flashes
the day code
representing
a day of the week.
3. Refer to llable A
3-9, and
press
the
Up
key
below the Selector display
until the day code of
the day that
you
want to change
appears
in
the
Selector display.
4.
Press the Enter key
to save the
setting. The
Selector display stops
flashing
and the hour
shown in the Multipurpose
display flashes.
5.
Press
the
Up
or Down
keys below
the Multipurpose display until
four
dashes
(-
-
-
-)
appear
on the display.
(The
dashes indicate
that
no
setting has been
entered.)
6. Press
the Enter key
to save the setting. All
displays stop flashing.
7. Record
your
setting
in the forms
provided
at the end of this section.
Refer
to Records of
System
Settings.
To Delete
Times for
an Entire Day
To
delete times for
an entire day, follow
the
procedure
To Delete
a
Standby or Heater
Time
and turn the clock otf for
each feature: entering
standby, exiting
standby, turning heaters
on, turning
heaters off.
A3EN-04.[3V-X-4XXVI-1
3
4'l-3000v
lssued 5/00
e000 Nordson Corporation
All
rights
reserved

Nordson 3100V Series Specifications

General

Brand	Nordson
Model	3100V Series
Category	Melting Machines
Language	English