Nordson 3100V Series Customer Product Manual

A 4-10 Operation
Checking the Warning or Fault
Log
(contd)
Running a
System
Test
4.
Operating
Procedures for
Optional
Features
NOTE: Refer to
the
following
sections of this
manual
for additional
troubleshooting
and
repair
information:
The Hydraulbs
section contains troubleshooting and repair
procedures
for
the
pump
and manifold assemblies.
The
Control
section contains troubleshooting
and
repair
procedures
for system board and heating
zone
problems.
4. To clear the warning
log,
pressing
the CLEAR
FAULTS key.
After
you
have corrected a
problem
that caused the unit to register a
fault,
press
the
CLEAR
FAULTS key to run a system test. During the
five-second
test, the
following
occur:
.
All lights on the operator
panelturn
on.
o
lnformation
in the
Displays
area changes.
lf
your
unit has
special
features or
options,
such as
a
low-level indicator
or an inpuVoutput board, refer to lhe
Options
section of this manual
for
any operating
procedures.
a
a
Problem corrected? Result:
Yes
No
The FAULT light turns off when the test is
complete and the system will enter
the
monitor/scan mode.
The FAULT light stays on when the test is
complete.
Refer to
Checking
the Fault Log
in this section.
A4EN{6-[3V-A-AAXV]-1
41
-3000v
lssued
5/00
o
2000 Nordson Corporation
All dghls reserved

Nordson 3100V Series Specifications

General

Brand	Nordson
Model	3100V Series
Category	Melting Machines
Language	English